Fein Slugger JMU 137 QW Manual Del Usuario página 27

OBJ_BUCH-0000000355-002.book Page 27 Tuesday, March 12, 2019 4:36 PM
en
27
Feed (figure 18).
Fig. 18
Work only with the absolutely required
amount of feed. Excessive feed can lead to
breakage of the application tool and loss of
the magnetic holding power.
To generate feed, turn the spoke handle man-
ually while the drill motor is switched on.
The scale can be used with "inch" or with
"cm" graduation.
Mounting the spoke handle is described
under „Mounting the spoke handle".
cm
inch
2.
1.
inch
cm
3.