Fein Slugger JMU 137 QW Manual Del Usuario página 30

OBJ_BUCH-0000000355-002.book Page 30 Tuesday, March 12, 2019 4:36 PM
en
30
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted cables and compo-
nents can cause serious injuries. Have the
required service carried out only through an
authorized Slugger repair facility.
Renew stickers and warning indications on
the power tool when aged and worn.
When the machine's power
CAUTION
supply cable is damaged, it
must be replaced using a specially prepared
power supply cable with GFCI safety switch
(*), available from the Slugger customer ser-
vice agent.
Use only original spare parts.
Products that have come into contact with
asbestos may not be sent in for repair. Dis-
pose of products contaminated with asbestos
according to the applicable country-specific
regulations for such disposal.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the power
tool from the power supply in order to avoid
accidents.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed.
Environmental protection, disposal.
Sort scrapped power tools and accessories for environmental-friendly recycling. For further
information, please contact your specialist shop.
When using in environments
WARNING
with conductive dust in the air,
such as when working metals, this dust can
settle in the interior of the power tool. This
can impair the total insulation of the power
tool. Therefore, regularly blow out the interior
of the power tool from outside via the venti-
lation openings with dry, oil-free compressed
air; always wear eye protection when doing
this.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
Cooling-lubricant system.
Flush the cooling-lubricant system with
water, clean and drain it completely when not
using the machine for periods longer than
two weeks.