Engage The Mower Blades - Snapper 2691525-00 Manual Del Operario

14
Wheel Drive
1. Stop motion of the Rear Engine Rider by pushing the
clutch/brake pedal (A, Figure 9) all the way down to
apply the brake.
Mower Blade
1. Stop the mower blade by releasing the blade pedals (A,
Figure 15) or moving the blade lever (B) to OFF.
15
12
Mowing
DANGER
This machine is capable of amputating hands and feet, and
throwing objects. Failure to observe the following safety
instructions could result in serious injury or death.
• Only operate the machine in daylight hours or good
artificial light.
• Avoid holes, ruts, bumps, rocks, or other hidden
hazards.
Uneven terrain can overturn the machine or cause
operator to lose their balance or footing.
• Do not direct discharge material toward anyone. Avoid
discharging material against a wall or obstruction as
material may ricochet back toward the operator.
• Stop the blade(s) when crossing gravel surface.
• Do not leave a running machine unattended. Always
park on level ground, disengage the attachment, set
parking brake, stop engine and remove starter insert or
key.
Adjust Cutting Height
Adjust the cutting height by raising or lowering the deck lift
lever (A, Figure 16) into the desired height of cut notch (B).
16

Engage the Mower Blades

1. With the engine running, move the engine speed control
to FAST.
2. Move the blade lever (A, Figure 17) to ON, then press
the blade pedals (B) to hold the blade lever in the ON
position.