Cebora KINGSTAR 400TS Manual De Servicio página 70

CEBORA S.p.A.
□ Press "back" until the main screen appears.
□ Press the START button briefly.
♦ Gas begins to flow out of the torch (pre-gas time).
♦ The wire starts to feed out of the torch, the wire feed motor begins
to operate it.
♦ When the torch button is released there is no post-gas phase
because it is present only if welding occurred.
□ Turn knob I to set "V-I-m/min." parameters to be used or
thickness of material to be welded
□ Position the torch by the workpiece to weld and press the torch
START button.
♦ Start welding. Use the knob and/or controls on the torch to obtain
current voltage levels best suited to the welding required.
♦ During welding, output current and voltage are shown both on
LCD display H and display on wire feed unit A.
♦ In the cooling unit, pump (26) and fans (2) come on or remain in
operation for a certain amount of time.
□ Release the torch START button.
♦ The arc turns off in the set OFF phase.
♦ The gas outflow continues for the post-gas time set.
♦ In the cooling unit, pump (26) and fans (2) stop after a certain
amount of time when the start button is released.
3301045
NO
Correct?
YES
NO
Correct?
YES
NO
Correct?
YES
70
(see section
3.5.3)
(3.5.4, 3.5.6,
3.5.7, 3.5.9)
(3.5.3, 3.5.8,
3.5.10, 3.5.11,
3.5.12)
17/09/2019