Fein GRIT GXE Instrucciones De Uso página 10

en
10
Extraction device
➤ The machine can be connected via sleeve (16) to an
exhauster.
Repair and customer service.
Repairs may be carried out only by qualified per-
sons in conformity with the valid regulations.
For repairs, we recommend our FEIN customer service
centre, the FEIN authorised service centres and FEIN
agencies.
Carry out the following maintenance daily:
Blow out the ventilation slots (9) at the motor
housing and the marked locations with com-
pressed air (see instruction label).
➤ Remove any deposits from within the housing.
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's guarantee. For further
details on this, please contact your specialist dealer, your
national FEIN representative, or the FEIN customer serv-
ice centre.
Declaration of conformity.
GRIT declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Originalsprache Englisch/Deutsch
Environmental protection, disposal.
Stationary machines should be sorted for environment-
friendly recycling in accordance with national laws.
Specifications.
Type
Reference number 7 90 10 ...
No-load speed [rpm]
Power input [W]
Voltage [V]
Frequency [Hz]
Weight according to EPTA-
Procedure 01/2003 [kg]
Class of protection
Connection diagrams.
Type GXE, Appendix 62
Type GXE2V, Appendix 63
Noise emission values.
REMARK: The sum of the measured emission value and
respective measuring inaccuracy represents the upper
limit of the values that can occur during measuring.
Measured values determined in accordance with the cor-
responding product standard (see last page in this
Instruction Manual).
GXE GXE
500 40 3 500 40 3
1 440 1 730
2 200 2 200
3x 400 3x440
50 60
32 32
I/ I/
A-weighted emission pres-
sure power level measured
at the workplace L
pA
(re 20 µPa), in decibels
Measuring uncertainty K
in decibels
Measured A-weighted sound
power level L (re 1 pW),
wA
in decibels
Measuring uncertainty K
in decibels
Operating conditions
Speed [rpm]
Material
Dimension
Wire brush
Wear ear protection!
GXE AUS GXE AUS
506 44 3 506 44 3
1 730 1 730
2 200 2 200
3x400 3x440
60
32
I/ I/
Idle Sanding
78.5
,
pA
4
87
,
wA
2.5
3000
Stainless
–
Pipe, dia-
– 42.4 mm
GRIT by
– Fein 0.35
GXE2V
500 23 3 500 23 3
1 440
2 200
3x230
60 50
32 32
I/
91
4
98
2.5
3000
steel
metrer
GXE2V
1 730
2 200
3x220
60
32
I/