Publicidad
Idiomas disponibles
Idiomas disponibles
Demo:
with:
Test Signal
Specs
Scope settings
Trigger
Modes
Purposes
a) Calibrate the Oscilloscope so it displays the signals correctly (possible using the "Autoset" mode).
b) Select the XY mode with CH1 on X and CH4 on Y, or CHA in X and CHB in Y.
c) If required, return to "X(t) mode" in order to demonstrate the use of automatic measurements (e.g. square
rise time) and phase measurements (manual, automatic).
Rising time measurement
METRIX Oscilloscope Demo Kit
MTX3x5x SPO
OX 6000
& MTX105x SPO
OX 6000-II
Type
2 out-of-phase signals, triangle and pseudo-square
Vpp ≈ 3.2 V - F ≈ 1.7 kHz - square rise time ≈ 24 µs - Signal delay ≈ 40 µs
20 ms/div. - MAIN = 500 mV/div. - AUX = 500 mV/div.
XY (Display Menu) – neither "Min/max", nor "Repetitive Signal" (Horizontal Menu)
X(t) and XY modes using out-of-phase signals
Present the automatic measurements with markers (F, square rise time)
Present the phase measurements (manual, automatic)
This casebook example involving a hysteresis loop is often used
for educational purposes.
It demonstrates the relative interests in displaying the channels on
a time basis and an XY display mode.
It is used to demonstrate the simplicity of configuring the XY mode
and of access to automatic phase measurement, which is one of
its uses.
Manual phase measurement
SCOPIX
HANDSCOPE
no. 2 : Hysteresis
Standard on MAIN
Automatic phase measurement
Chapter II - 21
a) b)
Publicidad
