Tabla de contenido
Publicidad
10
Belaying
10A. Belaying the leader: 100 kg
Use a dynamic rope certified to EN 892.
Device on the harness (position e): Before use, verify the rope is
correctly installed. The braking side of the rope is held in one hand
and the climber's side in the other. To facilitate rope glide, focus
more on pushing the braking side of the rope into the device rather
than pulling the climber's side of the rope. To stop a fall, firmly grip
the braking side of the rope. To lower a climber, the manipulation of
the device is similar to the description found under «Descent».
100 kg MAXIMUM
11
Other use
Occasional
rope climbing
Device attached
to the harness
(position c or d).
For greater
efficiency, take up
slack as you stand
up using the rope
clamp (B17). Never
allow slack between
the rope clamp and
the I'D.
12
Heavy loads, exceptional uses for experts only
These operations must only
be performed by rescuers
specifically trained in these
uses.
For heavy loads, shock-
loading must be avoided.
technical notice I'D L 2
10B.
Belaying: 100 kg
Belaying a second, and
hauling (usage without
redirecting the rope
through a carabiner).
Warning, in the case of
an error (rope installed
backwards) the anti-error
catch will not work in this
position.
Device on the anchor
(position e): the belayer
holds the braking side of
the rope with one hand,
and the second's rope with
the other. Take in slack
regularly. To stop a fall,
firmly grip the braking side
of the rope. To lower a
climber, the manipulation
of the device is similar
to the description found
under «Lowering from an
anchor» (use a braking
carabiner).
12A. Evacuation:
Accompanied descent, device
on the harness
Maximum load: 200 kg
A braking carabiner must be used.
100 kg MAXIMUM
200 kg MAXIMUM
D205000n (230914)
5
Publicidad
Tabla de contenido
