Setting Up The Clamping Position En; Setting Up The Compressed-Air Motor En - Abicor Binzel BRS-LC Instructivo De Servicio

5 Putting into operation
1 Mount milling cutter (2) along with milling cutter seat.
2 Tighten milling cutter (2) (min. 20 Nm).
5.5 Setting up the clamping position
Gas nozzle
1
Setting up the clamping position
Fig. 7
 See also Fig. 4 Putting into operation on page EN-9
1 Move the torch with the gas nozzle (1) vertically to the tool axis (milling cutter axis) over
the BRS-LC (3) (P1).
2 Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle (1) lies evenly
against the prism (2).
5.6 Setting up the compressed-air motor
Clamping device
1
2 Gas nozzle
Setting up the compressed-air motor
Fig. 8
 See also Fig. 4 Putting into operation on page EN-9
1 Loosen the compressed-air motor from the guide block (4) by removing the screws (3).
2 Pull back the compressed-air motor (5) in its fastener.
3 Place the required distance sleeve (7) on the milling cutter (6).
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
EN - 11
1
Prism
2
1
7
6
5
Screws
3
4 Guide block
2
3
Maintenance unit BRS-LC
3
2
3
4
Compressed-air motor
5
6 Milling cutter
BRS-LC
Distance sleeve
7