Perry TE526 Manual Del Usuario página 24

3 - INSTALLATION
3.3 - FASTENING THE WALL-MOUNTED BASE
“
Disconnect the 230V~ mains voltage
“
Fasten the base of the thermostat with the screws supplied: to the wall, to the rounded or rectangular recessed box via the relative
paired holes ( ). A
“If the thermostat base is to be fastened onto a metal wall, apply the two special insulating washers to the two screws.
EN
A
A fastening holes of the base: mounted to the wall, rounded or rectangular recessed box -
B corrugated cable duct, rounded or rectangular recessed box -
C fastening teeth of the thermostat -
D screws to fasten the wall-mounted base to the rounded or rectangular recessed box and insulating washers -
To ensure the thermostat is fitted correctly to the wall-mounted base, the latter must not be bent due to the screws
being tightened too much to the rounded or rectangular recessed box.
24
C
3 2 1
8 9
6 7
B
C
A
D