Possible Faults And Solutions - Perry TE526 Manual Del Usuario

7 - POSSIBLE FAULTS AND SOLUTIONS

FAULT
The display of the thermostat is off
The symbol blinks on the display
The symbol remains constantly lit
on the display
A desired operation is not performed when
the touch screen is touched
The thermostat works but the system is
not activated
The temperature fluctuates too much
between hot and cold
In the mode, the anti-freeze
temperature setting is not displayed
DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC EQUIPMENT (EU directive 2002/96/EC)
When this symbol is found on the product or on its packaging, it indicates that this product cannot be disposed of as household waste.
It must be delivered to a specific collection point where electrical and electronic equipment is recycled, such as:
- retail outlets, if a new product is bought, similar to that being disposed of
- local collection points (waste collection centres, local recycling centres, etc). By ensuring that the product is disposed of correctly, you will help prevent
potential negative consequences for the environment and health, which can be caused by this product being disposed of inappropriately. Recycling the
materials will help conserve natural resources. For more detailed information about recycling this product, please contact your Local Council, household
waste disposal service or the shop where you purchased the product.
Attention: in some EU countries, the implementation of the European Directive 2002/96/CE does not include this product in the field of application,
therefore these countries are not obliged to dispose of such products in collection points at the end of the product life.
CAUSE
No batteries entered or flat batteries
Incorrect battery polarity
The batteries are about to run out
The batteries are flat
The four areas (markers) are
separated from one another by a
non-sensitive line.
It is difficult to press with your finger
System's power disconnected
The thermostat is not connected
properly
The thermostat is not set in accor-
dance with the type of system
connected
The anti-freeze temperature has
been excluded or the system is set to
from Summer mode (cooling)
SOLUTION
Check that the batteries have been entered
Verify the polarity of the batteries
Replace the batteries within 30 days
Replace the batteries
make sure you are pressing within the
sensitive areas
press with a non-metallic instrument (e.g.
cotton swab tip)
Check that the ground fault protector or
switch is not OFF
Contact the installer
Contact the installer
Cancel the secret code by following the
relative procedure in the guidelines given in
the PROGRAMMABLE FUNCTIONS chapter
EN
37