Perry TE526 Manual Del Usuario página 30

5 - ISTRUZIONI D'USO
4 - USER INSTRUCTIONS
4.4 - TELEPHONE PROGRAMMER OPERATION
The telephone programmer
allows you to control the
thermostat from a distance via
the contact connected to
relative terminals ( refer to the
E l e c t r i c a l c o n - n e c t i o n s
EN
paragraph ).
Telephone programmer
Closed contact
Open contact
Closing the contact: when the thermostat is in the reduction temperature mode (
(antifreeze , it applies the ) comfort
indicate its activation (Fig. 1).
The temperature setting or the operation mode of the thermostat can be changed at any time by
pressing the key or the desired area.
When the first change is made to the thermostat by pressing any button, the
displayed so as to indicate that the contact of the programmer is still closed. This can be opened at a
later stage (Fig. 2).
Opening the contact: the thermostat applies the
(if not excluded) refer to Fig. 3 (note: the air-conditioner goes off if the thermostat works in cooling
mode ). The symbol blinks on the display to indicate its activation. Press the
thermostat (Fig. 3) to return to its regular operation (example in Fig. 4).
Attention: the controls to open and close contacts are effective within 1 minute.
Note: should the user not remember the status of the thermostat and/or the programmer (e.g. in a
mountain house), s/he should apply a double switch for the thermostat to be reset to a safe status via
telephone activation.
Example: If you must activate the
contact must be opened and closed. Contrarily, to activate the
be closed and opened.
30
T Set
ON
its
Thermostat operation
in comfort temperature
in anti-freeze temperature
temperature mode . The
mode with an
Comfort mode and have doubts on the status of the programmer, the
OFF anti-freeze mode
e.g. Telephone
programmer
Contact
mode
mode
)or in
symbol blinks on the display to
symbol is constantly
anti-freeze temperature
Mode button on the
, the contact must
T Set
ON
Fig. 1
T Set
Mode OK
Fig. 2
T
Set
Mode OK
Fig. 3
T
Set
Mode OK
Fig. 4