Positioning The Workpiece / Tool Rests And Eye Guard Mounts; Preparing For First Use; Switching On And Off; Grinding A Workpiece - Parkside PDOS 200 A1 Instrucciones De Utilización Y De Seguridad

Before use / Preparing for first use
j
M ount the double grinding machine on a firm,
level surface, if at all possible on a fixed sup-
port, e.g. working surface, workbench. Use the
four mounting holes
(not supplied). Refer to Figure C.
Positioning the workpiece / tool
Q
rests and eye guard mounts
To ensure safe working, the workpiece / tool rests
the eye guards and the eye guard mounts
3
must be correctly positioned.
j
C heck and correct the settings at frequent intervals
to ensure even wear on the grinding wheels
Adjusting the workpiece / tool rests:
1) To adjust the setting, first loosen the adjuster
screw .
6
2) Bring the workpiece / tool rest
the grinding wheel
the grinding wheel
tool rest must be no more than 2 mm.
5
3) Retighten the adjuster screw
using your hand that the grinding wheel
movement is true and free.
Adjusting the eye guard mounts:
1) To adjust the setting, first loosen the fastening
screw .
14
2) Bring the eye guard mount
grinding wheel
4
grinding wheel
4
must be no more than 2 mm.
3) Retighten the fastening screw
using your hand that the grinding wheel
movement is true and free. A worn out grinding
wheel needs to be replaced. This is necessary
4
when the specified gap cannot be achieved even
after readjusting the positions of the workpiece /
tool rest and / or the eye guard mount
5
36 GB/MT
and suitable fixings
8
close up to
5
, the distance between
4
and the workpiece /
4
and check
6
4
close up to the
2
, the distance between the
and the eye guard mount
and check
14
4

Preparing for first use

Q

Switching on and off

Q
Switching on:
j
P ress the On / OFF switch
position to switch the device on and run it
at a constant speed.
Switching off:
j
, P ress the On / OFF switch
5
position to switch the device off.
2

Grinding a workpiece

Q
.
4
NOTE: Use the fine grinding wheel for precise
grinding tasks (grade "A80M").
NOTE: Use the coarse grinding wheel for rough
grinding tasks (grade "A36M").
j
S witch on the machine as described above.
j
T o grind metal tools or metal items, place the
workpiece on the workpiece / tool rest
slowly bring it up to the grinding wheel
j
P ress the workpiece carefully against the grind-
ing wheel
the device. When grinding always use the
circumferential end face (not the sides) of the
grinding wheel only (See Figures D, E, F).

Replacing a grinding wheel

Q
2
carrying out any tasks on the device itself and
when you are not using the device, always pull the
mains plug out of the mains socket.
J
D o not use damaged grinding wheels.
J
. O nly use grinding wheels with details that cor-
2
respond with those given on the device rating
plate. The circumferential speed should be
equal to or greater than the value given on the
device rating plate.
j
O nly grinding wheels with markings indicating
the manufacturer, the type of adhesive, dimen-
sions and permitted circumferential speed are
into the "I"
9
into the "0"
9
. Pressing too hard can overload
4
RISK OF INjURy! Before
and
5
.
4