Maintenance - Imetec ECO EXTREME PRO Instrucciones Para El Uso

• Switch off the vacuum cleaner by pressing the ON/Off
the power cord (14) from the power socket.
• Press the automatic cord winding button (15) to wind the power cable [fig.f1].
Hold the plug while winding the cable in order to prevent whiplash.
ATTENTION! The vacuum cleaner has a motor protection thermostat,
which intervenes in the case of overheating (caused by the inlet opening,
filters, etc. being clogged). If it is triggered, press the ON/OFF
button to switch the appliance off and let it cool down completely for a
few hours. Verify whether dust has clogged the filters or the inlet opening
before restarting the appliance.
ATTENTION!
Switch the appliance off and disconnect the plug from the socket before
opening the appliance! Make sure all cleaned parts are completely dry
before reusing the appliance.
CLEANING THE APPLIANCE
When necessary, clean the appliance with a damp cloth.
ATTENTION!
DO NOT USE SOLVENTS OR OTHER AGGRESSIVE OR ABRASIVE
DETERGENTS. OTHERWISE, THIS MAY DAMAGE THE SURFACE.
CLEANING THE COMBINATION BRUSH (4)
With the motor ON, rub the brush with your hand to remove the dust and fluff, which will be
drawn.
CLEANING THE DUST COLLECTION SYSTEM (16)
ATTENTION! Empty the dust container (16E) and clean the HEPA premotor
filter (16D) after each use.
• Clean the dust collection system following the instructions below, paying attention to
the pictures in the illustrative guide.
• Press the locking buttons of the flexible suction pipe (6) and disconnect the flexible
suction pipe (5) from the appliance.
CLEANING THE DUST CONTAINER (16E)
• Press the release button of the dust collection system
system (16) from the appliance [fig.G1].
• Press the upper cover opening/locking button (16B) to open the upper cover (16A) [Fig.G2].
• Empty the container.
• fit the upper cover back on (16A) ensuring the couplings with the dust container (16E)
are perfectly engaged and the upper cover opening/locking button (16B) is perfectly
engaged as well.
• fit the dust collection system (16) back onto the vacuum cleaner ensuring the position
lock clicks.

MAINTENANCE

button once (8) and unplug
(9) to extract the dust collection
EN
(8)
13