3-Wall Alcove Installation - Jacuzzi COMFORT PURE AIR Serie Instalación Y Operación De Instrucciones

Drop-in Installation (con't)
Install the unit, inserting the motor/pump end first,
9
lowering the bathtub into the opening as shown in
the illustration.
Inspect all fittings, plumbing, and control lines
10
after inserting to insure the components are not
damaged, disconnected, or contacting the finish
surface substrate or support members.
Align the bathtub and connect the drain.
11
Turn on the power supply to the dedicated GFCI
12
protected circuits and check system operation.
Caulk around the perimeter of bathtub to seal the
13
space between the rim and the finished deck.

3-Wall Alcove Installation

Install the drain/overflow according to the
1
manufacturer's instructions. Refer also to the
Technical Specifications Manual.
Watertight installation of the drain is the installer's
responsibility. Drain leakage is excluded from the
Jacuzzi Luxury Bath warranty of this product.
Install the faucet at this time. It is recommended that
2
the faucet be installed by a qualified plumber.
Install the flange (purchased separately) according
3
to the instructions that are included with the kit. If the
bathtub is equipped with an integrated flange, skip this
step.
Turn off the power supply to the GFCI protected
4
circuit.
Insulation may be placed within the bathtub surround,
5
except around the motor/pump.
Connect flex water supply lines to faucet and plug
6
power cords into GFCI outlet.
Place the bathtub into the niche. Screw the flange to
7
the wood stud. It may be necessary to shim the unit
to close up any gaps between the wood stud and the
flange.
Align the bathtub and connect the drain.
8
Inspect all fittings, plumbing, and control lines after
9
inserting the bathtub to insure the components are
not damaged, disconnected, or contacting the finish
surface substrate or support members.
Turn on the power supply to the dedicated GFCI
10
protected circuits and check system operation.
Complete all finish work around the perimeter of
11
bathtub to seal the space between the rim and the
finished deck.
Page 12
Screw
www.jacuzzi.com
Comfort Pure Air™ Bath
Figure 8
Tile Flange
Figure 9
Figure 10
Installation and Operation
Cement Board
Mortar
Finishing
Material
Plastic Filler
Silicon/Sealant
Bath Rim
Stud Wall
1˝ x 4˝ (not for
support)
Tile
Stud Wall
Cement Board
Tile Adhesive
Caulking
Mounting
Screw
Tile Flange
Stud
1˝ x 4˝
(not for
support)