Festool PLANEX LHS 2 225 EQI Manual De Instrucciones Original página 14

English
8.4 Replacing the backing pad [8]
CAUTION
Worn backing pad, backing pad revs up
Risk of injury from flying parts
► Check backing pad regularly for wear.
► Change backing pads if necessary.
The backing pad is attached to the power tool
with eight screws.
► To remove the abrasive and interface pad,
see Sections 8.2
► Loosen the screws by turning a suitable
screwdriver anticlockwise.
14
and 8.3.
Remove the backing pad [8-1] carefully
►
by gently pulling it. Take care to ensure that
no dirt enters the eccentric housing.
► Extract dirt particles if necessary.
► Place new backing pad so that the open­
ings in the backing pad match with the
screw threads.
► Insert all eight screws one after the oth­
er.
► – Tighten all screws clockwise in a
crosswise sequence and check that they are
securely in place.
8
8-1