Connecting A Power Tool Via Bluetooth; Working With The Electric Power Tool; Extension Cord - Festool PLANEX LHS 2 225 EQI Manual De Instrucciones Original

English
8.8

Connecting a power tool via Bluetooth

Connecting to the Festool Work app
The power tool can be configured with the
Festool Work app.
► Press the Bluetooth
power tool for approximately three seconds
until the LED display starts to flash blue.
For a period of 60 seconds, the power tool is
ready for connection.
► Follow the instructions provided in the
Festool Work app to authorise the secure
connection.
By pressing the Bluetooth
switch between the factory settings of the
power tool and the configurations in the
Festool Work app.
Connecting to the mobile dust extractor
► Activate the mobile dust extractor's auto­
matic mode (see the operating manual for
the mobile dust extractor).
► Press the connection button on the mobile
dust extractor or on the remote control
once (see the operating manual for the mo­
bile dust extractor/retrofit receiver mod­
ule).
► Switch on the power tool.
The mobile dust extractor starts up and the
power tool is connected until the mobile dust
extractor or the power tool is manually switch­
ed off. If another power tool is connected via
Bluetooth to the mobile dust extractor, the
®
connection is also lost.
LED indicator [1-3]
LED indicator Meaning
LED lights up The configurations made in the
green. Festool Work app are active, e.g.
the surface control light has
been dimmed.
LED flashes After being switched on, the
blue once. power tool searches for a mobile
dust extractor ready for connec­
tion.
LEDs flash The power tool can be connected
blue. to a mobile device.
LED lights up The power tool can be connected
blue. via Bluetooth ® to a mobile de­
vice or a mobile dust extractor.
LED flashes Software update mode active.
purple.
16
button [1-2] on the
®
® button, you can
®
LED indicator
LED flashes
red.
LED lights up
red.
9 Working with the electric
power tool
Risk of injury
► Always hold the power tool with both hands
using the indicated gripping surfaces, see
Section 9.2.
► Before switching on the power tool, make
sure that all locking levers are completely
closed.
9.1

Extension Cord

If an extension cord is required, it must have a
sufficient cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
you the correct cord diameter as a function of
the cord length for this tool.
Cord Size in A.W.G
Tool`s Ampere Rating
3-6
6-8
8-10
10-12
12-16
Wire Sizes in mm
Tool`s Ampere Rat­
ing
3-6
6-8
8-10
Meaning
The power tool has overheated.
Further information can be
found in the Festool Work app
and in Section 14.
There is an electronic fault. Fur­
ther information can be found in
the Festool Work app. If the fault
persists, contact an authorised
customer service workshop.
WARNING
Cord Length in Feet
25 50 100
18 16 16
18 16 14
18 16 14
16 16 14
14 12 -
2
Cord Length in Meters
15 30 60
0.75 0.75 1.5 2.5
0.75 1.0 2.5 4.0
0.75 1.0 2.5 4.0
150
14
12
12
12
-
120