Install The Car Kit In A Vehicle - Nokia CK-20W Manual De Instrucciones

Ocultar thumbs Ver también para CK-20W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I n s t a l l a t i o n
If you cannot connect the stereo output of the car kit to the stereo/auxiliary
input of the car radio (for example, to play music from the car kit in stereo),
select the A1 option, set the audio mode to mono, and use the loudspeaker
supplied with the car kit. If the car radio does not have a mute connector, you
can leave the mute line unconnected. For more information, see Power cable
p. 26.
If you connect the car kit to a stereo/auxiliary input (an aux-in or cd changer
connector) of the car radio, select the B1 option, and set the audio mode to
stereo. If the car radio does not have a mute connector, you can leave the mute
line unconnected. Do not connect the car radio to the mono output of the car kit.
The mono output is designed to be used with a loudspeaker and does not work
properly when connected to a car radio.
If you select an installation option that uses the supplied loudspeaker, voice calls,
ringing tones, and navigation instructions can be heard even if the car radio is
switched off. Instead of using the supplied loudspeaker, you can connect to the
car kit one of the car speakers with a relay if the impedance of the speaker is at
least 4 ohms. In this case, connect the mute connector to the relay as well. If the
impedance is over 8 ohms, the output power is significantly lower than normally.
Set the mono or stereo mode
Set the car kit to the mono mode (default setting) or the stereo mode depending
on the selected installation option. To switch between the modes, switch off the
car kit if it is on, press the Navi wheel, and within 5 seconds, press and hold
for 10 seconds.
When you switch to the mono mode, the car kit sounds a high beep, and the
indicator light flashes slowly for a few seconds.
When you switch to the stereo mode, the car kit sounds a low beep, and the
indicator light flashes in the rhythm of the beeps.

■ Install the car kit in a vehicle

This section describes how to install the car kit parts in a vehicle. The parts are
explained in Parts p. 8.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido