Important; Bumper Bar - BABYTREND SS88 Manual De Instrucciones

ASSEMBLY

IMPORTANT!

stroller, please follow these instructions carefully. Please
keep these instructions for future reference.
IMPORTANT!
inspect this product for damaged hardware, loose joints,
missing parts or sharp edges. NEVER use if any parts are
missing or broken.
IMPORTANT!
Remove stroller from box. The front and rear
wheels MUST be installed prior to use.
FRONT WHEELS
To attach the front wheels, unfold stroller as
described in the following section:
1) • Unlock the release lever (Fig. 1a) and
unfold stroller frame by pulling upward
on the stroller handle until the frame
locks (Fig. 1b).
• Lean the stroller backwards and push
each front wheel assembly into the front
wheel housing until they lock into place
(Fig. 1c).
NOTE: Pull on the wheel assembly
to ensure that it is securely attached
to the stroller.
5
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
To ensure safe operation of your
Before assembly and each use,
Adult assembly is required.
REAR WHEELS
2) • Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 2).
NOTE: Pull on the rear wheels to ensure
that it is securely attached to the stroller.

BUMPER BAR

WARNING:
use bumper bar to carry seat
with child inside. The bumper
bar is not a carrying handle.
3) • Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it locks into place (Fig. 3a).
NOTE: The bumper bar must be securely
attached before using this product.
Fig. 1a
• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar
upwards to access the seat (Fig. 3b).
Fig. 1b
Fig. 1c
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Do not
Fig. 2
Fig. 3a
Fig. 3b
6