Transport And Storage; Requirements For Product Use - Festo CMFL Instrucciones De Utilizacion

CMFL
3

Transport and storage

• Ensure the following storage conditions are met:
– short storage times
– cool, dry, shaded, corrosion-resistant storage locations.
4

Requirements for product use

Warning
Danger of injury. Moving masses can cause injury to human beings and damage
to property.
• Make sure that, in the travel range,
– nobody can place his/her hand in the path of the moving parts (e.g. with
a protective screen),
– there are no foreign objects.
It should not be possible to touch the ADNE-LAS until the mass has come to
complete rest.
Note
Malfunctions will occur if the device is not used correctly.
• Be sure to always comply with the specifications in this chapter.
• Compare the limit values specified in these operating instructions with your
application (e.g. forces, torques, temperatures, masses).
Only compliance with the load limits allows operation of the product in
compliance with the relevant safety regulations.
• Take into consideration the ambient conditions at the location of use.
Corrosive elements in the environment (e.g. ozone) will reduce the service life of
the product.
• Comply with the regulations of the trade association, the German Technical
Control Board (TÜV) or corresponding national regulations.
• Remove transport packaging such as films and cardboard.
The packaging is intended to be recycled on the basis of its constituent
materials (exception: oiled paper = other waste).
• Use the product in its original condition without any unauthorised
modifications.
• Note the warnings and instructions on the product and in the relevant
operating instructions.
Festo – CMFL – 1304b English 25