Operation; Service And Maintenance; Repair - Festo CMFL Instrucciones De Utilizacion

CMFL
7

Operation

Note
In case of subsequent changes (e.g. revised mounting position or load), the
system characteristics will also change.
• Repeat the teach procedure with every change in the entire system.
• Consider that acceleration and braking in the end positions are automatically
adapted to the load.
To achieve that, the motor current increases with rising load.
8

Service and maintenance

Warning
Signals from the controller can cause inadvertent movements of the
ADNE-LAS.
• Switch off the controller for all work on the end-position controller and
secure it from being switched on again unintentionally.
On cleaning and maintenance:
• If necessary, clean the end-position controller with a soft dry cloth.
9

Repair

• Recommendation: Send the CMFL to our repair service.
The necessary fine adjustments and tests will then be taken especially into
account.
• Information on spare parts and aids can be found under:
www.festo.com/spareparts
Festo – CMFL – 1304b English 37