Kit Assembly - Metra 95-8245CHG Instrucciones De Instalación

ISO DDIN radio provision
1. Secure the radio brackets to the radio with
the screws supplied with the radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Test the radio for proper operation.
3. Secure the radio/bracket assembly into the
dash with the factory hardware.
4. Attach the panel clip mounts onto the radio
housing using the (4) #4 x 3/8" Phillips
screws supplied. (Figure B)
5. Attach the clips previously removed from
step 3 under dash disassembly, to the panel
clip mounts on the radio housing.
6. Clip the radio housing over the radio/
bracket assembly.
7. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A) (Figure B)
REV. 9/19/2017 INST95-8245CHG
3