Madas EVP/NC Manual Del Usario página 19

5.1 - CONNECTOR/ELECTRONIC BOARD REPLACEMENT
fig. 1
29 28
1
2 34
g. Loosen the 4 fastening screws (1) of the cover (2);
h. Remove the over (2) and loosen the cable gland (3) with a 22mm commercial spanner;
i. Loosen the screws of the main terminal board (32) and remove the existing electric wiring by extracting the cables from
the terminal board and cable gland (3);
j. Using an 8 mm socket spanner, loosen the fastening nut (29) and remove it together with the toothed washer (28);
k. Remove the connector/board (31) as shown in
two wires that come out;
l. Wire the two wires coming out from the rear terminal board (33) of the new connector/board.
IMPORTANT: Being careful not to pinch the two cables, in the centre pin (30) insert: the new connector/board + toothed
washer (28) + nut (29). With an 8mm socket spanner, tighten the nut (29);
Proceed as specified in points c-f in section 3.2.
g
j
Madas Technical Manual - REV. 0 of 10
31
32 30 3
. Loosen the screws from the rear terminal board (33) and remove the
k
h
k
May 2018
th
20
i
l
19
4
EVP/NC - EVPF/NC
33
31