Wayne Dalton 8000 Instrucciones De Instalación Y Manual Del Usuario página 13

4
Installing Fully Adjustable
Jamb Brackets
NOTE: If you have quick install jamb
Tools Needed:
brackets, skip this step and complete
None
Step 5.
The bottom jamb bracket is always the
shortest bracket included with your door.
If three jamb brackets are included with
you door, the bottom center bracket
is the middle bracket in height. The
top jamb bracket is the tallest bracket
included.
To attach the bottom jamb bracket,
locate the lower hole/slot pattern of the
vertical track. Align the slot in the jamb
bracket with the lower hole of the hole/
slot pattern in the vertical track. Secure
jamb bracket, using
(1) 1/4"- 20 x 9/16" track bolt and (1)
1/4"- 20 fl ange hex nut.
Place the center jamb bracket over
the hole/slot pattern that is centered
between the bottom jamb bracket and
fl agangle. Align the slot in the jamb
bracket with the lower hole of the hole/
slot pattern. Loosely fasten the bracket
onto the track with (1) 1/4"- 20 x 9/16"
track bolt and (1) 1/4"- 20 fl ange hex
nut.
Repeat if a third jamb bracket is
required, equally spacing the distance
between the two center jamb brackets
and the bottom jamb bracket and
fl agangle.
NOTE: Doors over 7'3" high get (3) sets
of jamb brackets.
NOTE: The bottom jamb bracket is the
shortest in length that is included with
your door. It does not necessarily mean
the "short" (ST-0) jamb bracket.
NOTE: After completing this step,
continue with Step 6.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
ST-0
ST-2
HOLE/SLOT
PATTERN
JAMB
BRACKET
1/4"- 20
FLANGE
HEX NUT
JAMB BRACKET
3RD SET
ST-1
2ND SET
ST-3
1/4"- 20 X
9/16"
1ST SET
TRACK BOLT
VERTICAL
TRACK
VERTICAL
TRACK
13