Wayne Dalton 8000 Instrucciones De Instalación Y Manual Del Usuario página 24

16
Attaching Adjustable Flagangle
Tools Needed: NOTE: If you have quick install
fl agangle, skip this step and complete
9/16" Socket
Step 17.
7/16" Socket
Align the bottom of the horizontal track
with the vertical track. Hand tighten the
Ratchet Wrench
horizontal track to the fl agangle with
(2) 1/4"- 20 x 9/16" large head ribbed
9/16" Wrench
track bolts and (2) 1/4"- 20 fl ange hex
nuts.
Level
Hammer
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE
Flat Tip
SE CURED AT REAR, AS OUTLINED
Screwdriver
IN STEP 20, OR DOOR COULD
FALL FROM OVERHEAD POSITION
CAUSING SEVERE OR FATAL
INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the fl agangle using (1) 3/8"- 16 x 3/4"
truss head bolt and (1) 3/8"- 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the top
section in place, installed in Step 15.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE
TO TOP SECTION.
NOTE: After completing this step,
continue with Step 18.
24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
to Horizontal Track
WARNING
FLAGANGLE
1/4"- 20 FLANGE
HEX NUTS
3/8"- 16 X 3/4"
TRUSS HEAD BOLT
HORIZONTAL ANGLE
1/4"- 20 X 9/16"
LARGE HEAD
RIBBED TRACK
BOLTS
3/8"- 16
HEX NUT
FLAGANGLE