Insert Welding Wire - Parkside PMSG 200 A1 Instrucciones De Funcionamiento Y De Seguridad

MIG welding
To fix it in place, rotate in a clockwise
direction. If you are in any doubt,
then please contact a professional.
Connect the cable assembly with
„
direct connection
ate connector. To fix the connection,
tighten the fixing ring
wise direction.
Then connect the earth cable
„
the corresponding connector, marked
with the "+" and to fix the connec-
tion in place rotate in a clockwise
direction.
z Insert welding wire
Please unlock and open the
„ Note:
cover of the wire feed unit
pushing the release knob upwards.
Unlock the roller unit by turning the
„
roller mount
27
Fig. F).
Pull the roller mount
„
(see Fig. F).
Make sure that the end of the
Note:
wire does not come loose and cause the
roll to roll out on its own. The end of the
wire may not be released until during
assembly.
Completely unpack the welding
„
wire reel , so that it can unrolled
15
without difficulty. Do not release the
wire end yet.
Place the wire reel on the shaft.
„
Make sure that the roll unwinds on
the side of the
29
(see Fig. G and M).
Place the roll mount
„
lock it by pressing and turning it
clockwise (see Fig. G).
Undo the adjustment screw
„
swing it downwards (see Fig. H).
Turn the thrust roller unit
„
side (see Fig. I).
76
GB/MT
to the appropri-
10
in a clock-
38
with
4
, by
1
anti-clockwise (see
off the shaft
27
wire feed guide
back on and
27
and
25
to the
26
Loosen the feed roll holder
„
turning it anti-clockwise and pull it
forwards and off (see Fig. J).
On the top of the feed roll
„
whether the appropriate wire thick-
ness is indicated. If necessary, the
feed roll has to be turned over or
18
replaced (see Fig. E). The supplied
welding wire (Ø 1.0 mm) must be
used in the feed roll
ified wire thickness of Ø 1.0 mm.
The welding wire must be positioned
in the upper groove!
Erect the feed roll holder
„
and screw clockwise direction.
Remove the torch nozzle
„
pulling and turning it clockwise
(see Fig. K).
Unscrew the welding nozzle
„
(see Fig. K).
Guide the cable assembly with direct
„
connection away from the weld-
10
ing device as straight as possible
(place it on the floor).
Take the wire end out of the edge of
„
the spool (see Fig L).
Trim the wire end with wire scissors
„
or a diagonal cutter in order to
remove the damaged, bent ends of
the wire (see Fig. L).
The welding wire must be
Note:
kept under tension the entire time in
order to avoid a releasing and a roll
out! Therefore it is recommended to
carry out the work with an additional
person.
Push the welding wire through the
„
wire feed guide
Guide the welding wire along the
„
feed roll and push it into the cable
18
assembly holder
Swivel the thrust roller unit
„
towards the feed roll
Mount the adjustment
„
(see Fig. O).
Set the counter pressure with the
„
adjustment screw
by
28
, check
18
with the spec-
18
again
28
by
7
14
(see Fig. M).
29
(see Fig. N).
30
26
(see Fig. O).
18
screw
25
. The welding
25