Swing Away Hangers With 4-Way Latch; Folding Frame - Ki Mobility Catalyst 5Vx Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
G. Swing Away Hangers with 4-Way Latch
1. Installation
a. Place swing away pivot saddle into the receiver on front frame
tube (Fig. 8:A).
b. Rotate the footrest so that it aligns with the frame and locks into
place in the latch block (Fig. 8:B).
2. Swinging the Footrest Away
a. Push or pull on release lever.
b. Rotate footrest outward or inward as desired.
3. Removal
a. To remove footrest, push or pull release latch.
b. Lift the footrest straight upward to remove. You may also swing
the footrest inward or outward before lifting it off.
H. Folding Frame
NOTE: In order to not damage the chair, always ensure there is adequate room for the chair to open
and close without coming in to contact with hard surfaces.
1. Before attempting to fold the frame, remove any seating system that may be attached to the
seat or back.
2. Flip up the footplates.
3. Lift upwards on the strap (Fig. 9:A) that runs horizontally across the seat sling. This will
disengage the cross brace supports from the seat hooks, allowing the chair to fold.
4. To unfold the frame, push down on one side of the cross brace tubes (Fig. 9:B) which attach
the seat upholstery to the frame. Push down until the horizontal cross brace supports have
completely engaged with the seat hooks.
A
20
A
Fig. 9
B
Fig. 8
B