Scope Of Delivery; Warranty; Safety Instructions; Safety Devices - Kärcher IVR-B 20/6 Manual Del Usuario

Information on accessories and spare
parts can be found at www.kaerch-
er.com.

Scope of delivery

The scope of delivery for the appliance
is shown on the packaging. Check the
contents for completeness when un-
packing. If any accessories are miss-
ing or in the event of any shipping dam-
age, please notify your dealer.

Warranty

The warranty conditions issued by our
relevant sales company apply in all
countries. We shall remedy possible
malfunctions on your appliance within
the warranty period free of cost, provid-
ed that a material or manufacturing de-
fect is the cause. In a warranty case,
please contact your dealer (with the
purchase receipt) or the next author-
ised customer service site.
(See overleaf for the address)

Safety instructions

ATTENTION
Risk of explosion
Injuries due to parts being flung around
Do not use the device in explosive
spaces.
CAUTION
Danger of injury
Hands could become trapped when re-
moving and replacing the container lid.
Wear suitable protective gloves.
CAUTION
Danger of injury
Electrical shock in the event of a short-
circuit
The maximum permissible mains grid
impedance at the electrical connection
point (see Technical data) must not be
exceeded.
Contact your electricity supplier in the
case of any uncertainties regarding the
6
mains grid impedance at your electrical
connection point.
ATTENTION
Damage to the device
Do not use the device without a filter or
with a damaged filter.
 In the event of an emergency (e.g. if
you vacuum up flammable materi-
als, in the event of a short-circuit or
other electrical faults), switch off the
device and remove the mains plug.
 After completing work, switch off the
device and remove the mains plug.

Safety devices

Motor circuit breaker
The motor circuit breaker shuts off the
device if power consumption it too
high.

Device description

For the figures, please refer to the
graphics page
Illustration A
Suction hose connection
1
Locking clip
2
Container lid
3
Handles for the container lid
4
Suction turbine
5
Power switch
6
Mains cable
7
Container
8

Initial startup

For the figures, please refer to the
graphics page
1. Bring the device into the working po-
sition.
2. Check the lid on the container for a
correct fit.
3. Lock the locking clip.
4. Insert the suction hose into the suc-
tion hose connection.
Illustration B
English