Chamberlain MotorLift ARM 1703EML Instrucciones De Montaje página 10

Representative Locking Mechanism
CAUTION
To prevent damage to garage door and operator: Ensure that
turning the outside handle will not actuate ANY of the locking
mechanisms supplied with the door.
• Remove all door latching mechanisms (Figure 3), and
secure any locking bars in the open position.
1
1
1. Spring
2. Latch
3. Door Plate
• Remove inside door handle but leave the barrel in
place in door (Figure 4).
• Ensure that turning the outside handle will not actuate
ANY of locking mechanism supplied with the door.
Failure to do so will result in serious damage to your
door and operator. This is not covered by the
Manufacturer's Warranty.
1
•. Unbolt the extension arm from the door arm (Figure 5).
1. Connection Arm
114A3167C-GB
FIGURE 3
3
4
5
FIGURE 4
4. Canopy Door
5. Inside of Canopy Door
6. Remove inside Door
Handle
FIGURE 5
2
2. Canopy Door Arm
• Disengage the outer trolley from the inner trolley by
pulling down the manual release rope and handle
(Figure 6).
• Connect and secure the extension arm to outer trolley
with the clevis pin and ring fastener provided with the
garage door operator.
1. Trolley
6 2. Clevis ring
3. Bolt
3
FIGURE 6
1
5
2
3
4
6
4. Extension Arm
5. Trolley disengage lever
6. Manual release