Commissioning; Unpacking; Connection; Software Installation - Bosch FSA 500 Manual Original

Ocultar thumbs Ver también para FSA 500:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
en
26 | FSA ��� | Commissioning
4.

Commissioning

4.1

Unpacking

Remove the packaging from all components
supplied.
4.2

Connection

1. Supply the FSA 500 with power by way of the power
supply unit.
2. Switch on the FSA 500.
3. Charge the battery.
 During charging: LED B lights (violet).
 Battery charged: LED B lights (blue).
4. Remove the power supply unit and power cord.
5. Connect the sensors at the measurement unit slots
provided (refer to Fig. 2).
i
Only connect the 30 A (1 687 225 020 - special ac-
cessory) and 1000 A current probes and the adapter
cable 1 684 465 513 if necessary.
"
FSA 500 ready for operation.
|
1 689 989 115
2011-09-20
4.�

Software installation

i
Pay attention to the system requirements be-
fore starting installation. The FSA 500 can
only be operated by way of a PC/Laptop with
FSA 500 CompacSoft [plus] software installed. The
FSA 7xx /FSA 050 CompacSoft [plus] software can-
not be installed on DCU 130 or on PC/laptop simul-
taneously.
i
For motor vehicle identification via customer data
or key number as well as for control unit diagnosis
with CAS[plus], the latest ESI[tronic] software (Info
type A and C) must be installed on the PC/Laptop
and released. In this case it is advisable to install the
ESI[tronic] software first.
1. End all open applications.
2. Insert the "FSA ���CompacSoft[plus]" DVD in the
DVD drive.
3. Start "Windows Explorer".
4. Start 'D:\RBSETUP.EXE' (D = DVD drive letter).
 Set-up is started.
5. Heed and follow the instructions on the screen.
i
During software installation there must be a USB ca-
ble connection to the PC/laptop when prompted by
FSA 500. If the Would you like Windows to search
for new hardware dialogue box opens, select Yes,
this time only and then <Continue> to confirm. Next
select Install software automatically (Recommend-
ed) and then <Continue> to confirm.
i
The PC/Laptop may automatically be re-started during
installation of the FSA 500 CompacSoft[plus] software.
Installation of the FSA 500 CompacSoft [plus] software
continues after the re-start.
6. Re-start the PC/Laptop to successfully conclude installa-
tion of the FSA 500 CompacSoft [plus] software.
"
FSA 500 CompacSoft [plus] is installed.
"
DSA starts automatically.
Robert Bosch GmbH

Publicidad

Tabla de contenido
loading

Tabla de contenido