Load Trays 2 And 3 - HP LaserJet 9040 Guía De Instalación Inicial

Step 12. Load Trays 2 and 3
1
2
3
4
6
22 Printer Setup
This section describes how to load A4- or letter-size paper. For
instructions on loading and configuring other sizes and types of media,
see the use guide.
CAUTION
To avoid a paper jam, never open a tray while the printer is printing from
that tray.
To load Tray 2 and Tray 3
1 Open the tray until it stops.
2 Adjust the left (Y) paper guide by pressing the tab on the guide and
set the guide to the correct paper size.
3 Adjust the front (X) paper guide by pressing the tab on the guide
and set the guide to the correct paper size.
4 Load a stack of media with the top of the stack toward the rear of
the tray. For single-sided printing, the side to be printed should be
down. For double-sided printing, the first side to be printed should
be up.
Note
For information about printing on special media, see the use guide.
5 Set the paper lever to Standard if both guides are set to the same
Standard marking, such as Letter or A4. Otherwise, set the lever to
Custom.
6 Close the tray.
7 The paper size and type for this tray appears on the printer control
panel. Press to verify or see the use guide to make changes.
8 Repeat steps 1 through 7 to load the other tray.
Note
For information about loading Tray 4, see the install guide that came
with Tray 4.
CAUTION
Never store paper or other items in the area to the left of the paper
guides. Doing so can permanently damage the tray.
ENWW