Connecting The Appliance - Bosch KGS36300 Modo De Empleo

EN.qxd 05/05/05 7:23
Connecting the
appliance
After installing the appliance, wait at
least 1 /
2
up. During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see
Cleaning).
The socket should be easily accessible.
Connect the appliance to 220–240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket
must be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non-European country, check on the
rating plate whether the indicated vol-
tage and current type correspond to
the values of your mains supply. The
rating plate is located in the appliance
at the bottom left-hand side. The
mains connection cable may be repla-
ced by an electrician only.
Page 17
hour until the appliance starts
Fascia
Fig. W
1. Door switch for the light inside
the REFRIGERATOR.
2. Refrigerator on/off indicator light.
3. Ultra-fast freezing button.
Switches „super" freezing on and
off. „Super" freezing is used to
freeze large quantities of fresh food
and should be switched on up to
24 hours before the fresh food
is placed in the freezer compart-
ment.
When „super" freezing has been
switched on, the refrigerating unit
runs constantly and the freezer
compartment drops to a very low
temperature.
Ultra-fast freezing can be turned off
manually by pressing button 3
again.
4. Ultra-fast freezing indicator light.
The lit lamp indicates that „super"
freezing is on.
On/Off button for the freezer
5.
compartment
Switches the freezer compartment
on and off separately.
en
17