Performing A Functional Test - Waeco MS-BE6 Instrucciones De Montaje Y Uso

Performing a functional test

➤ Wait two seconds.
✓ During this time the LED on the control lever will not be lit.
✓ After two seconds the LED will blink a corresponding number of times to
the vehicle type selected, e. g. twice for Opel Movano.
✓ Following this the LED on the control level will go out and will not light up
for three seconds.
✓ The LED will light up and remain lit constantly to indicate that
programming is complete.
➤ Switch the ignition off.
✓ The LED on the control lever goes out.
➤ Wait ten seconds.
➤ Disconnect the slotted pieces (fig. b, page 7).
➤ Go for a test drive (see chapter "Performing a functional test" on page 34).
9 Performing a functional test
Note
I
The lowest speed at which the speed regulator can operate is
approximately 30 km/h and the highest approximately 140 km/h
➤ Start the vehicle.
➤ Switch on the speed regulator using the ON/OFF button on the control
lever.
➤ Drive at a speed of 40 to 50 km/h.
➤ Press the SET button to activate the speed regulator.
✓ The speed controller gently takes on the speed and maintains the driving
speed constantly.
34
MagicSpeed Accessory