Publicidad
Idiomas disponibles
Idiomas disponibles
When the Top Case is mounted, especially when it is loaded,
greater side wind susceptibility will cause a change in vehicle
handling characteristics while riding, taking curves, and brak-
ing!
Exercise caution in high winds! Due to the changes in vehicle
handling characteristics, accelerate gradually to the permitted
maximum speed of 150 km/h!
Distribute the load evenly and secure it well to prevent slipping!
Ensure that the load never exceeds 5 kg!
Do not use a high-pressure cleaner to clean the Top Case as
the high pressure may damage the seals!
Use a neutral cleaning agent (water with neutral soap)!
Scope of supply
1x Top Case (36 liter capacity)
1x sliding plate
4x assembly kit
4x collar screw M8x35
4x sliding bushing
4x rubber washer
4x shims
4x sliding guide
4x spacer
4x rubber mount
1x locking cylinder
Scope of supply: locking cylinder
1x locking cylinder
12x wafer
15x spring for wafer
2x snap-in plate
1x spring for snap-in plate
1x O-ring
This kit contains many small parts. It is advisable to carry out
assembly while sitting at a table!
NOTE
The springs
for the wafers differ from spring
plate in terms of the lower spring rate.
The snap-in plate
can be identifi ed by the fact that no number is
stamped on it.
Locking cylinder assembly
- Insert springs
into chambers
for the snap-in
,
and
.
11
Publicidad
