Coupling The Driveshaft; Principle Of Operation - Nogueira VMN 4.0 Manual De Instrucciones

Coupling the Driveshaft

1- Make sure that the driveshaft has the clearance to maneuver.
2- Couple the side of the safety screw in the gearbox of the
machine.
3- Assemble the other point on the tractor.
4- Secure the currents of protective cover of the driveshaft for will
not become loose and avoid accidents.
5- In the end of the operation, turn the tractor at the maximum
angle to make sure the driveshaft is to the left limit.
Warning:
Whenever you replace the driveshaft, replace it
with a security screw.

Principle of Operation

Note:
When the "left" or "right" terms are used, it is considered as a reference point the position of
the operator of the tractor.
The mixer VMN 4.0 is a device designed to perform mixing and discharge in different situations in
height. His project has been designed with flexibility and efficiency in this application.
The mixer performs a balanced mixture of ingredients may be they (sorghum, grass, corn silage, bran
concentrated salts and other organic matter etc.).
Attention:
Always untie the hay and put it separate and uniform way inside the mixer.
Never leave ropes, bags, wire or any other material that is not only necessary for
animal feed ingredients inside the mixer.
The belt speed depends on the product being downloaded and can be regulated by a valve attached at
the beginning of the hose of the hydraulic motor.
The rotor consists of mixer blades and knives to mix well, place slices of longer fibers by contact
between the knives with the cracker of hay, making a homogeneous mixture of ingredients.
12
Operation Technical Manual