Operating Adjustments - Nogueira VMN 4.0 Manual De Instrucciones

Operating Adjustments

Connecting the hydraulic hoses
a) On the remote control tractor, use two outputs hydraulic: one
for opening and closing the discharge port and the other for
activating the unloading belt.
The photo with the levers (2) may vary according to
the mark
operating instructions.
b) Remove the protective caps (1) remote control and hoses.
c) Connect the terminals of these hoses pushing firmly against
the remote terminals.
d) Bleed the circuit: to remove the air from the hoses and
cylinders, turn the levers of the remote control several times in
both directions until the end of the course.
The machine should be coupled to the tractor.
Removing the hydraulic hoses.
a) To disconnect the hydraulic hoses is necessary to relieve the
system pressure. For this, turn off the tractor and after,
sometimes crank levers (2) relieving the system.
b) With the levers (2) control in neutral, pull the hoses quickly: a
disconnection occur with minimal loss of oil.
c) Next, replace all protective caps (1).
and tractor size, and thus follow the
VMN 4.0
2
1
17