Positioning Of The Disc Blades; Operation - Nogueira SOFT 600 Manual De Instrucciones

Positioning of the disc blades

The Soft rotor is shipped from the factory adjusted to the best position for most products. However, if
necessary, your blades can be repositioned as necessary.
For the greatest density in spreading and shorter distance, use
For spreading further, use
The change in blade position must be done equally on all the blades, by simply loosening the screws
and fastening nuts.
STANDARD

Operation

Before actuating the Soft, carefully check the following:
- Check if there are no objects or tools inside the machine.
- Check if there are no people or animals nearby the machine.
After the Soft is properly coupled, lubricate and adjust it so that the product being spread, then start the
tractor motor, turn on the power take-off and increase the acceleration speed until reaching 540 RPM.
NOTE:
Look at the tractor instrument panel, the marking corresponding to 540 RPM in the power take-off
is achieved in most tractors by a RPM between 1700 and 2100 RPM on the tachometer.
position 2 .
POSITION 1
SOFT 600 / 900
position 1 .
POSITION 2
fig.35
25