GYS STARTIUM 330E Manual Del Usuario página 18

Translation of the original instructions
◊ TIMER feature
The TIMER feature (n°14) is used to set a charging time from 10 to 120 min (by steps of 10 min) and allows to start
the charge when the battery is disconnected or below 1V.
The charge when using the TIMER feature is manual. This has the following consequences :
• Whatever is the battery health status (sulfated, short circuited, voltage < 1V), the charge will always be triggered.
• The charge starts even if the battery connection is faulty: clamps disconnected or in short circuit There is a risk of
sparks if the connection instructions are not observed.-
Two indicators can help to check that the charge has started :
- The display (n°2). -It alternates between the battery voltage and the remaining time in minutes.
- The voltage and minutes LEDs (n°3 and 4). They remain on and alternate at the same time as the display.
The charge may be be stopped in several ways :
- At the end of the selected time.
- When there is a power supply cut
- By pressing the START/STOP button.
◊ Charging several batteries simultaneously.
It is possible to charge several batteries simultaneously by connecting them in parallel. The positive terminals connected
to the red clamp and the negative terminals connected to the black clamp. These batteries or battery groups must be
of the same voltage, 12V or 24V.
Charging batteries in series is not recommended.
USE IN STARTER MODE (INTERFACE, P.5)
◊ Preliminary precautions
• Do not disconnect the battery fom the vehicle. Connecting the battery can lead to the vehicle's memory loss and a
potential impossibility to restart it.
◊ Starting
Connect the starter to the battery while following the recommended procedure (p.6). Press the START ENGINE button
(n°13). Press the START/STOP button; a precharge will automatically start.
• The «START ENGINE» mode detects sulfated batteries and will thus refuse to start the vehicle. The
machine will automatically start the desulfating procedure in order to protect on-board electronics.
• If the battery is excessively damaged (e.g. sulfated), the charger will block the start. In this event, the
startium intermittently indicates « CIP » (Charge in Progress) and 0%. This means that battery recovery
is in progress. As long as «CIP» appears on the display, it is not possible to start the vehicle.
Product
STARTIUM 330E
STARTIUM 480E
STARTIUM 680E
STARTIUM 980E
Make sure to follow the recommended precharge time, depending on the battery capacity.
Once the precharge is done, go to the vehicle's dashboard. The «start» feature will activate when the first attempt to
start is initiated (by turning the key). The attempt time must be for 10 secs maximum (a countdown appears on the
display).
If your engine does not start, wait 2 minutes between each start attempt.
Nb : If the vehicle does not start, it may be a problem other than a faulty battery e.g. alternator, glowplug...
After usage, follow the recommended disconnection procedure (p.15-16).
18
STARTIUM 330E / 480E / 680E / 980E
Battery capacity
50 - 60Ah
50 - 100Ah
50 - 160Ah
50 - 220Ah
Starting Battery capacity
Instantaneous
Instantaneous 100 -160 Ah
Instantaneous 160 - 220 Ah
Instantaneous 220 - 250 Ah
Starting
60 - 80Ah 5 min pre charge
5 min pre charge
5 min pre charge
5 min pre charge
EN