Using The Countdown Timer - Oakley D1 Manual Del Usuario

08 D1 / D.5 INSTRUCTION MANUAL
VIEWING THE DATA
Press the MODE button repeatedly until "DATA" appears in the menu bar. The amount of free
memory is displayed.
BEST
LAP-
DATA
Figure 3
TO SELECT A RUN: Press the SELECT button. Run
numbers are displayed below the menu bar. The
best lap time (and corresponding lap number) from
each run is automatically displayed.
TO REVIEW A RUN: Press the FORWARD or
REVERSE button to view data from each run
(Figure 3). After data from the final lap is
displayed, "STOP" appears for 3 seconds. The
display then changes to the final lap time and
TIME
shows the total elapsed time for the selected run.
TO CLEAR ALL MEMORY: Press the MODE
button repeatedly until "CHRONO" appears in the
menu bar. If the timer is running, press the
STOP/RESET button. If the timer has not been
reset to zero, press and hold the STOP/RESET
button for 2 seconds. Press the MODE button again
so that "DATA" appears in the menu bar. Press and
hold the DELETE button for 3 seconds.

USING THE COUNTDOWN TIMER

The countdown timer can be programmed to perform various functions when it reaches zero. It can be set to
stop, repeat the countdown, or activate the chronograph. The D.5 wristwatch has one multi-function countdown
timer. D1 has three multi-function countdown timers. (When one is operating, the other two cannot be used.)
Press the MODE button repeatedly until "TIMER" ("TMR" for the D.5 wristwatch) appears in the menu bar (a).
For the D1 wristwatch, press the FORWARD or REVERSE button to select timer 1, 2 or 3. The number appears
below the menu bar (b).
TO SET THE COUNTDOWN TIMER:
1. Press and hold the LOCK/UNLOCK button until the
seconds display flashes.
2. Press the FORWARD or REVERSE button to set seconds.
3. Press the SELECT button to activate the minutes
display. Press the FORWARD or REVERSE button to
change the setting. (Press and hold the FORWARD or
REVERSE button to change the setting rapidly.) Press
the SELECT button to activate the hours display.
Press the FORWARD or REVERSE button to change
the setting.
TIMER
4. Press the SELECT button to activate the function
display. Press the FORWARD or REVERSE button to
select one of the following functions: count down
and STOP, count down and REPEAT, or count down
and activate the CHRONOgraph (c). (The final
function is useful for giving an audible signal to start
a timed sprint.)
5. Press the LOCK/UNLOCK button at any time to save settings.
[COUNTDOWN TIMER CONT. ON NEXT PAGE]
D1 / D.5 INSTRUCTION MANUAL 09
(a)
"TMR" for D.5
TIMER
TIMER TIMER
(c)
2
(b)
D1 only