Preliminary Tasks On The Indoor Installation; Assembly; Preparing New Foundation - Mennekes AMEDIO Proffesional+PnC 22 T2S Manual De Instrucciones Y De Instalación

5.2 Preliminary tasks on the indoor
installation
T
DANGER
Fire hazard due to overload
There is a fire hazard caused by unsuitable supply line
configuration.
f Configure the supply line according to the technical
data and the configuration of the device.
Î "4 Technical data"
When configuring the supply line (cross section
and cable type), give due consideration to the
following local conditions:
„ Type of installation
„ Cable parameters per unit length
„ Line length
f Route the supply line and the data line, if applicable, to
the desired location.
Residual current circuit breaker
„ The device has a differential current sensor
for DC residual current monitoring > 6 mA for
each charging point with tripping characteris-
tics in accordance with IEC 62752.
„ Each charging point must be protected by
a dedicated type B residual current device
if it is subject to the scope of IEC 60364-7-
722:2018.
„ Each charging point must be protected by
a dedicated type A residual current device
if it is subject to the scope of HD 60364-7-
722:2016.
„ Compliance with national regulations is man-
datory.

5.3 Assembly

5.3.1 Preparing new foundation

9 0 0
Fig. 6: Formwork [mm]

Observe separate foundation plans on the website:
https://www.chargeupyourday.com/
f Excavate the foundation hole according to the speci-
fied dimensions.
f Insert right-angled shaft elements (2) as permanent
formwork.
f Route the supply line (1) and the data line (if applicable)
in conduit (4) and into the formwork.
f Close the opening (3) of the conduit with expanding
foam to avoid leakage of the concrete.
MENNEKES recommends using the foundation
set that is available separately.
MENNEKES recommends using the base plate
that is available separately.
6 0
0
1
2
3
4
11
EN