Electrolux EWG 147540 W Manual De Instrucciones página 11

Washing cy- Soil
cle Level
icon
Quick
Super Quick
1)
1) We recommend you to reduce the load sizes (see
Washing programmes table).
Important! The Time Manager cannot be
selected with the programmes
The availability of these soil level icons
change according to the type of fabric as
shown in the following chart.
Fabric
Cottons
95°/90°C X
60°C/50°C X
40°C X
30°C X
Cold X
Synthetics
60°C/50°C
40°C
30°C
Cold
Delicates
40°C
30°C
Cold
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 8 (if you wish to change the Time Man-
ager option, you must cancel the running
programme and make your selection
again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to and then to the new pro-
gramme position. Start the new programme
Type of fabric
Very slightly soiled
items
Items used or worn
for a short time
.
Soil Level
X X X X
X X X X
X X X X
X X X X
X X X X
X X X
X X X
X X X
X X X
X X X
X X X
X X X
by pressing the button 8 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
X
PAUSE by pressing the button 8.
X
If the icon 7.10 after a few minutes disap-
pears from the display, the door can be
X
opened.
X
If the icon 7.10 does not go off, this means
X
that the machine is already heating or that
the water level is too high. Do not try to
force the door!
X
If you cannot open the door but you need
X
to open it you have to switch the machine
X
off by turning the selector dial to
few minutes the door can be opened (pay
X
attention to the water level and temper-
ature!).
X
After closing the door, it is necessary to se-
lect the programme and options again and
X
to press button 8.
X
AT THE END OF THE PROGRAMME
The machine stops automatically. Three
blinking zeros (
play. The pilot light of button 8 goes off.
Some acoustic signals sound for a few mi-
nutes.
If you set a programme or an option that
ends with water left in the tub, the icon 7.10
remains displayed. The door is still locked.
The water must be emptied out before
opening the door. During this time the drum
continues to turn at regular intervals until
water drain.
Follow the below instructions to empty out
the water:
electrolux 11
to cancel a pro-
. After a
) appear on the dis-