Fig. 4
c) Mounting the door
Fix the hinges to the appliance by means of
the M5x15 screws. The hinges can be ad-
justed to compensate for possible uneven
thickness of the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tight-
en the screw A again (Fig. 5).
Warning! Do not remove the screw B
(Fig. 5).
Fig. 5
B
d) Counter-magnet
The appliance is prearranged for a magnet-
ic closure of the door.
To enable a correct operation of this device,
it is necessary to screw the counter-magnet
ENVIRONMENT CONCERNS
Recycle the materials with the symbol
Put the packaging in applicable containers
to recycle it.
Help protect the environment and human
health and to recycle waste of electrical and
electronic appliances. Do not dispose
appliances marked with the symbol
the household waste. Return the product to
2
1
A
with
A (steel disk + rubber ring) into the inner
side of the door. Its position must corre-
spond to the magnet B on the appliance
(Fig. 6).
Warning! Do not remove the screw C.
Fig. 6
If the door has to be opened from left to
right, invert the position of the plates E, the
magnet D and the plate C. Mount the
counter-magnet D and the hinges A as pre-
viously described (Fig. 7).
Warning! Do not remove the screw B.
Fig. 7
E
your local recycling facility or contact your
.
municipal office.
PACKAGING MATERIALS
The materials marked with the symbol
are recyclable.
>PE<=polyethylene
>PS<=polystyrene
>PP<=polypropylene
electrolux 27
A
B
C
D
A
C
B