Connecting The Ac Power Cord - Sony MDS-JE520 Manual De Instrucciones

Hookups
Connecting the deck to an amplifier
Connect the amplifier to the LINE (ANALOG) IN/
OUT jacks using the audio connecting cords (supplied),
making sure to match the color-coded cords to the
appropriate jacks on the components: red (right) to red
and white (left) to white. Be sure to make connections
firmly to prevent hum and noise.
MD deck
ç
LINE
(ANALOG)
IN OUT
L
R
Ç
ç ç ç ç ç : Signal flow
Connecting the deck to a digital component such as
a CD player, DAT deck, digital amplifier, or another
MD deck
Connect the component through the DIGITAL
OPTICAL IN/OUT or DIGITAL COAXIAL IN
connectors with two optical cables (only one supplied)
and/or a coaxial digital connecting cable (not
supplied).
When using the optical cables
Take the caps off the connectors and then insert the plugs
parallelly until they click into place.
Be sure not to bend or tie together the optical cables.
MD deck
DIGITAL
COAXIAL OPTICAL
IN IN OUT
ç
Ç
ç ç ç ç ç : Signal flow
When using the coaxial digital connecting cable
MD deck
DIGITAL
COAXIAL
OPTICAL
IN IN OUT
Ç
ç ç : Signal flow
ç ç ç
Note
If the optical cables and/or the coaxial digital connecting
cable are not connected properly, "Din Unlock" and "C71"
may alternate in the display.
z
Note
Amplifier
If "Din Unlock" alternates with "C71", or "Cannot Copy"
TAPE / MD
appears in the display, recording through the digital
OUT IN
connector is not possible. In this case, record the program
L
source through the LINE (ANALOG) IN jacks with the
R
INPUT switch set at ANALOG.
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
deck is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to an AC outlet.

Connecting the AC power cord

Connect the AC power cord to a wall outlet or to the
Digital component
outlet of a timer.
DIGITAL
OPTICAL
IN OUT
Digital component
DIGITAL
COAXIAL
OUT
Getting Started
Automatic conversion of digital sampling rates
during recording
A built-in sampling rate converter automatically
converts the sampling frequency of various digital
sources to the 44.1 kHz sampling rate of your MD deck.
This allows you to record sources such as 32- and 48-
kHz DAT or satellite broadcasts, as well as compact
discs and other MDs.
220 – 240V
110 – 120V
5 EN