Keep-Warm Function; Drip Stop; Preparation - Beem FRESH-AROMA-SELECT Manual De Instrucciones

25

Keep-Warm Function

The device has an automatic keep-warm function. The hotplate remains switched on for approx.
40 minutes after each brewing process.
To end the keep-warm function prematurely, press the ON / OFF button (13).
If you are using the thermal jug, switch off the keep-warm function by pressing the
ON / OFF button. The device switches directly to stand-by mode.

Drip Stop

The device has a drip stop (4) which prevents water from dripping out of the fi lter compartment
when the jug has been removed from the device (Picture B).
When the device is in operation, the fi lter compartment (3) must be closed and a jug with a lid
placed on it must be placed beneath the fi lter compartment. The lid of the jug pushes the drip
stop upwards and the coffee can fl ow from the fi lter through the lid into the jug.
During the brewing process, the jug must not be removed from the device for longer than
30 seconds as otherwise the fi lter could overfl ow.

Preparation

PLEASE NOTE
• Do not operate the device without water or with less water than is required to reach the
MIN mark (approx. 250 ml). If this does happen, the device switches off automatically. In
this case, allow the device to cool down before water is poured in and the device is used
again.
• Never start a brewing process without a jug with a closed lid beneath the coffee
outlet.
1. Fill the water tank (9) with water (see the "Handling and Operation" chapter | "Filling the
Water Tank").
2. Insert the permanent fi lter (2) into the fi lter compartment (3) (see the "Handling and
Operation" chapter | "Inserting the Permanent Filter").
3. Pour the amount of ground coffee you want into the permanent fi lter using a suitable spoon.
We recommend one level coffee measuring spoon per 125 ml.
4. Place the glass jug (5) or the thermal jug under the coffee outlet (4).
5. Press the ON / OFF button (13) to start the brewing process. The operating lamp (11) lights
up during the brewing process. The water is transported from the water tank through the
permanent fi lter into the coffee jug.
6. After completing the brewing process, press the ON / OFF button to switch the device
to stand-by mode. Bear in mind that the fi rst press of the button only activates the display
lighting!
05958_DE-EN-FR-ES-IT_A5_V1.1.indb 25 05958_DE-EN-FR-ES-IT_A5_V1.1.indb 25
EN
18.01.2019 07:56:39 18.01.2019 07:56:39