Publicidad
Idiomas disponibles
Idiomas disponibles
9
9
8
10
6
11
11
- Mount the small right holder (1) on the engine guard using screw M6x20
(2) + countersunk washer M6 .
- Position the spacer ø20x10.5x44(3) on the right side between the small right
bracket (1) and the engine case; and attach screw M10x230 (4) + washer
M10 (5) and the 2.5mm spacer (6) with nut M10 (7).
NOTE:
Insert the screw from the right to the left.
2
- Remove the screws of the side stand bracket.
- Mount the small left bracket (8) on the engine guard with screw M6x20
(2) + countersunk washer M6.
- Mount the small left bracket with screws M10x35 (9) + washer M10 (45Nm,
Loctite 243).
Mounting with a center stand
4
- Mount the center stand (see Power Parts manual 3.211.574).
NOTE:
Do not mount the long pin (included with center stand). If the center
1
5
stand is already mounted, remove the long pin (10) and the spacer.
- Mount the small right bracket (1) on the engine guard using screw M6x20
(2) + countersunk washer M6 .
- Mount the small right bracket using hex screw M10x230 (4) (included with
center stand) + washer M10 (5) (45Nm, Loctite 243).
2
When mounting with the center stand, you must use the hex screw M10x230
(4) included with the center stand - different thread pitches.
NOTE:
Insert the screw from the right to the left.
12
- Remove the screws (11) and spacers on the left.
- Mount the small left bracket (8) on the engine guard using screw M6x20
12
(2) + countersunk washer M6 .
- Mount the small left bracket between the side stand bracket and left bra-
8
cket of the center stand using screws M10x45 (12) (included with center
stand) + washer M10 (45Nm, Loctite 243).
2
Check all connections for tightness after 50 km.
It is recommended that all connections be checked for tightness regularly.
3
7
1
2
9
12
9
12
6
4 5 10
8
2
Publicidad
