Disposal; Environmental Regulations; Troubleshooting; Warranty And Liability - Ega Master 79613 Manual De Instrucciones

Dispose worn out/defective machine tools according the local/national regulations.
Fully disassemble machine for the necessary disposal. Separate materials according to local
environmental specifications. Dispose environmentally hazardous greasing, cooling or cleaning
agents in order to avoid environmental contamination.
When working on or with the equipment, it is imperative to observe all legal requirements in
regards to waste-disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging agents, such as
•
•
•
•
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in
suitable containers!
In case of malfunctions check, if the instructions of this technical documentation are adhered to
and make necessary adjustments.The following table shows possible problems and causes:
Problem
a Machine does not start
b Machine turns too slowly
c Gear makes strong noise
d Other trouble
If necessary, send the machine to the manufacturer.
Unless otherwise specified, our "General Sales Terms" apply.
Warranty and liability claims in regards to persons or equipment damages are invalid, if one or
several of the following causes apply:
• Improper use of the machine.
• Improper assembly, startup, operation or maintenance of the machine.
• Operation of the machine with defect safety devices or improperly fixed or non-functioning
safety and protection devices.

DISPOSAL

ENVIRONMENTAL REGULATIONS

lubricating grease and oil,
hydraulic fluid,
coolant,
solvent containing cleaning agents

TROUBLESHOOTING

not connected to pneumatic
too low operation pressure

WARRANTY AND LIABILITY

Cause
Connecting and opening of
supply
increase operation pressure
Contact authorized expert
-
Contact authorized expert
-
Remedy
the pneumatic line
at the machine to 6 bar
company
company
43