KTM 60312964044 Manual De Usario página 6

9
8
6
9
- Route the cable on both sides along the existing lines to the headlight mask.
NOTE:
Ensure that the cables are not too taut so that the throttle grip can still func-
tion properly.
- Detach the protection cap (8) of the wiring harness connector (9) and keep
it in a safe place.
- Connect the plugs of the two heated grips to each other.
- Connect the heated grips with the wiring harness connector (9).
Final steps
- Mount the hand guards on both sides.
- Mount the headlight mask (see the Owner's Manual).
After installation, the entire lighting system and the heated grips must be
checked for proper functioning. Check the throttle grip to ensure that it can
move freely.
- To be able to use the heating function, Heat Grip in the SETTINGS must
be set to On.
- Press the UP or DOWN button until the "Heat Grip" menu appears on the
matrix display. Pressing the SET button opens the menu.
- Use the UP or DOWN button to navigate through the menu. Use the SET
button to select a heating level or to switch off the heated grips.