J.P. SELECTA MP-2006 Manual De Instrucciones página 69

needed month and press 'Enter' to finish setting. (Or you can input the figure: press 'Input' key,
there is an input window jump out for you to input necessary month. When input finishes, press
'Enter' to exit from input window. Press 'Enter' again, you can fulfill the setting of present
month).
Your can set other time according to the same procedure.
When setting finishes, press 'X' (quit) key to exit 'Set System Time' mode and return to start
mode.
4.4.4 Set Manual Temperature
When temperature electrode socket is connected with temperature sensor, meter will automatically
adopt the temperature of temperature sensor. Otherwise, meter will adopt manual temperature set
by user as current temperature. Press 'SETUP' key, select 'Set Manual Temperature' and press
'Enter', meter enters into 'Set Manual Temperature' part. It is displayed as follows:
Press once at 'Manual Temperature' displaying area, meter shows an input window which is
displayed as following chart. You can input relevant manual temperature value in input window.
When input finishes, press 'Enter' to finish the input. In case there is any mistake occurred, press
'Delete' button to input again. Press 'Cancel' to quit the input. When setting finishes, meter returns
back to start mode.
Display chart of 'Set System Time'
Press 'month' key repeatedly till your
Display chart of
Temperature'
'Set Manual
66