J.P. SELECTA MP-2006 Manual De Instrucciones página 74

When selection finishes, press 'X' (quit) key to exit 'Set pH STD Buffer Group' and return to
'View pH STD Data' mode.
(Please refer to appendix for distinguishable 10 standard buffer solutions.)
4.5.2 View 'pX STD Data'
In start mode, press 'VIEW' key, select 'pX STD Data', then press 'ENTER' to view 'pX STD
Data'. Displayed as follows:
On top of the screen is 'Previous STD' including STD time, STD point and present slope in
percentage in correspondence to STD buffer. At the bottom is the 'Current Ion Mode', i.e. all
above pX STD Data are in correspondence to this ion mode: on right side is
key, 'PRING' key, 'STD' key and 'SETUP' key.
If previous STD is multi-points calibration, user can press '<＝>'(move) key to show detailed
data of each STD point.
From here, user could calibrate electrode slope (please refer to calibration chapter for detailed
calibration procedure) directly by pressing 'STD'.
Please press 'PRINT' to print out STD data when the meter is connected with model TP-16
printer.
Press 'SETUP' button, you could set ion mode (please refer to chapter 'set ion mode' in previous
page). Press 'X'(quit) to exit view 'pX STD Data' mode.
4.5.3 View Conductive Measuring Parameter
Under start mode, press 'VIEW', select 'Cond Meas Para', then press 'ENTER' to view
Conductive measuring parameter which displayed as follows.
On top of the screen is Previous STD, at the bottom is present conductive parameter value
including 'Cell Constant' and 'Temperature Coefficient'. On right side is 'PRINT', 'STD' and
'SETUP' key for setting cell constant and temperature coefficient.
Display chart of view 'pX STD Data'
'<＝>'(move)
71