Printed Circuit Board M 00 - M15; Power Supply - Lincoln 236-13870-2 Instructions De Service

Owner Manual
Operating Instructions

Power Supply

Fig. 1: Jumper plugged on 15/30
Fig. 2: Jumper 15/30 has been removed
Signal output
Intermittent flashing signal
M 00 - M 15
*M 00 - M 15 is the designation of the respective version of the printed circuit board (refer to Combinations of the jumper positions in the
corresponding Technical Description). This designation is part of the pump model designation code mentioned on the nameplate of each
pump.
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Printed Circuit Boards M 00...M 15*
00002433a
00002613a
Industrial applications
· Supply voltage (+ and - ) plus machine
contact
· Only machine contact
Printed circuit boards M 00...M 07
• When the jumper is plugged on 30/15 the connections 15
and 30 are connected (bridged) within the printed circuit
board, see Fig. 19. The connection cable has 4 wires.
Printed circuit boards M 08....M 15
• Jumper 30/15 has been removed. The printed circuit board
must be connected to the power supply (+ and -) or to the
battery voltage (terminals 30 and 31). Refer to Fig. 17.
• The connection 15 can be used for the additional activation
as a function of auxiliary units or drives, etc. The connection
cable has 5 wires.
Applications on commercial vehicles
· Battery voltage (terminals 30 and 31)
plus driving switch (terminal 15)
· only driving switch (terminal 15)
2.6A-28003-B06
Page 3