Functions Of The Pushbutton And Signal Lamp; Fault Acknowledgement - Lincoln 236-13870-2 Instructions De Service

Owner Manual
Operating Instructions

Functions of the Pushbutton and Signal Lamp

Fig. 10: Indicated operating states
A - Fault indication
B - Indication of operation or acknowledged fault
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Pushbutton
• The following functions can be performed with the pushbut-
ton:
- triggering of an additional lubrication cycle - Press pushbut-
ton for over 2 seconds (> 2 s)
- fault acknowledgement < 1 s
- in the case of a fault, switch on pump again by pressing push-
button (> 2 seconds)
Note: It is also possible to acknowledge any fault or to trigger an
additional lubrication cycle via pushbutton 4 on the printed cir-
cuit board (Fig. 15).
1052b95
Signal lamp
• The signal lamp or the LED display fig. 9 indicates the opera-
ting state of the centralized lubrication system.
• The faults are indicated by different flashing frequencies of
the signal lamp or the LED display fig. 9. See "Fault indicati-
on".
2.6A-28003-B06
Page 7